How to Apply Inlay Stickers

Apply your inlaystickers to a surface by following these simple and easy step!

First of all,Please identify the location of stickers.
Use a dry cloth to clean the surface.Put it slowly from the edge.

modify guitar with inlay decal

Using a Pick or Nail squeegee the entrire decal suface.
Apply pressure to surface.
DO NOT remove transfer tape.

modify guitar with inlay decal

Remove the backing paper

modify guitar with inlay decal

Once you are satisfied with the position, Apply the sticker.

modify guitar with inlay decal

Apply the sticker by pressureing from the center to the edge with fingers.

modify guitar with inlay decal

Carefully peel away the transfer tape.

How To Apply Fret Markers

First of all, Please identify the location of stickers.
Use a dry cloth to clean the surface.
Put slowly from the edge.

Tree Of Life Fret Markers

How To Apply Binding Sticker

The material that is used in this product is "elastic."(stretching and shrinking).
White part is a blank space.

First, please catch this part and tear off from a sheet, and begin the work.
This part, cuts it later by scissors.

Please choose from the following methods
1)Butt joints.
Please stick it while pulling it little by little along the shape of the body.(Do not pull strongly)
Transparent tape that is enclosed in a pack is what you need when you are sticking it.
Please wrapped (band-aid-like) fingertips by this transparent tape.

They can prevent from adhering the oil of your hands to an adhesion side by this way.
Please cut the part which remained.
A scissors or cutting knife are available on it.
"Curved-Shape" corresponding to the part which is the acute angle of various guitars is enclosed in a pack.
Please fit a tip of sticker and a tip of body, and stick along the curve of body.

This product is available with joints of bindings by various ways.
When two binding pieces meet end-to-end, there are a few styles of joint you can use.

  • Butt joints are a simple meeting of one square end against another. I recommended this way.
  • Over-Lap joints are easier. Moderate length of overlap is about 2 cm.
  • Scarf joints are angled mating surfaces, and can be a good way to hide a joint.
    And it can be angled across either the top or the side of the binding strip.